tech tested battery and found ok at this time. Charging system not working due to broken belt. Advised to replace and recheck. Tech found debree in area of belt (side of motor). After replacement of drive belt, tech tested charging system and found no further issues at this time. Charging system 14.1 Volts. Engine oil low.
A/C COMPRESSOR DRIVE BELT – Remove & Replace – [Includes: Serpentine type Belt(s).]
Darryl H. gave our service a 5 star review on 10/6/2021
Front rotors with .008 run out. Front pads at 6mm. Rotors at 1.0811.082. Min specs is 1.106. Tech does not recommend to resurface front rotors with excessive run out to warranty brake shake. Rear Run out .004. Rotors at .710/.7089. Min specs .650.
DISC ROTOR – Remove & Replace – Front – [Includes: Replace Pads (if necessary). DOES NOT include refinishing.]
BRAKE PADS – Remove & Replace – Rear,Both Sides – [Includes: Clean, lube and/or replace Brake Hardware as necessary. Adjust Brakes (where applicable). Includes: Repack Wheel Bearings (where applicable). DOES NOT include refinishing.]
DISC ROTOR (ON VEHICLE) – Refinish – Each Additional – [DOES NOT include grind hot spots.]
DISC ROTOR (ON VEHICLE) – Refinish – One – [DOES NOT include grind hot spots.]
Donavohn C. gave our service a 5 star review on 10/4/2021
DISC ROTOR – Remove & Replace – Both,Front – [Includes: Replace Pads (if necessary). DOES NOT include refinishing.]
RT AXLE SHAFT ASSEMBLY – Remove & Install or Remove & Replace – Right side – [NOTE: For Independent Suspension Type Axles, Axle Shaft Assembly consists of Axle Shaft, Boots and Joints.]
Gary B. gave our service a 5 star review on 9/2/2021