Lower control arm bushings broken – left and right side. Sway bar link on dr side boot broken – Dr Side axle (inner boot) leaking grease. Dr side inner brake pad cracked – brake pads at 6mm. Rotors at .970/.975. Valve cover gasket leaking. Coolant leak under intake manifold, Coolant leak on front of engine next to oil filter. transmission pan gasket leaking.
CONTROL ARM – Remove & Replace – FWD Lower,w/o Engine Removal,Both – [DOES NOT include alignment.]
Adjust camber, caster and toe (where adjustable) Doesn't include removal of tabs, special adjustments additional cost.
Mark K. gave our service a 5 star review on 7/30/2025
CONTROL ARM – Remove & Replace – V6 Lower,w/o Engine Removal,Both – [Includes: Lowering Subframe. DOES NOT include wheel alignment.] – [DOES NOT include alignment.]
Adjust camber, caster and toe (where adjustable) Doesn't include removal of tabs, special adjustments additional cost.
Marcia H. gave our service a 5 star review on 6/27/2025
Front brake pads at 3mm/4mm. Rotors 1.057/1.060, rotors at spec. not able to resurface. Rear brake pads at 5mm. Ok at this time. Sway bar link bushings cracked. Engine air filter dirty – cabin air filter dirty. Brake fluid recommend as per maintenance.
DISC ROTOR – Remove & Replace – Gas Front,Both – [Includes: Repack Wheel Bearings (where applicable) and replace Pads (if necessary). DOES NOT include refinishing.]
Front Break pads: 8mm Rotors: 1.240 / 1.240 Rear: 6mm Rotors: 665/665 Tech test drove heard squeak in front. breaks okay at this time. Fluid good. Engine and Cabin air filter dirty, recommend for preventative maintenance.
CABIN AIR FILTER – Remove & Replace
Perform BG Fuel System Cleaning/Induction Cleaning Service
Clean Intake / Throttle Body Assembly
MASS AIR FLOW SENSOR – Remove & Install to Clean – w/Air Temp Sensor
Bob S. gave our service a 5 star review on 3/11/2025
DTC in system – P0420 Catalyst System Efficiency Below Threshold (b1) Pressure tested cooling system and found coolant leaking under intake manifold. Upon removal of intake – tech found manifold plate leaking – replaced gasket as needed.
light came on shortly after belt noise – DTC in system P0420 Catalyst System Efficiency below threshold (bank1) Transmission Pending Code – P0420 Cat System Efficiency, P0894 Transmission Component slipping, P2714n Pressure control Solenoid D performance or stuck off. After drive – tech inspected 02 sensor readings – found normal at this time. Tech reset system.
adjusted labor time with tensioner
SERPENTINE BELT TENSIONER – Remove & Replace – V8,5.7L Eng – [Includes: Replace Belt (if necessary).]
Monitors set – expt evap and sec. air system. At this time – transmission is shifting normal. No codes back on test drive.
if codes come back for transmission will need further diag & repairs.
Brent S. gave our service a 5 star review on 1/22/2025